Industry Insights
Product knowledge, selection, installation, maintenance and industry insights.
Industry Insights · 75
How to Adjust a Pneumatic Actuator That Is Not Fully Open or Closed - 5 Troubleshooting Directions
Introduction A pneumatic actuator not fully opening or closing generally refers to the valve product it is paired with not fully opening or closing - the common symptom is that it "won't shut off" or "won't open fully". There is more than one reason behind this: it may be an excessive leakage rate, or jamming by foreign matter, the positioner…
How to Adjust a Pneumatic Valve That Won't Close Tight - 6 Main Causes and Step-by-Step Adjustment
Introduction A pneumatic valve that does not close tightly leads to media leakage, energy waste and even safety accidents. This "internal leakage" problem looks simple, but its causes may lie in the actuator, the valve body, the positioner, the mechanical transmission, the control signal or even the installation. This article systematically analyzes the 6 main causes of a pneumatic valve…
Pneumatic Valve Working Principle + Troubleshooting 4 Common Faults
Introduction A pneumatic valve uses clean compressed air as its power source and, through an actuating mechanism such as a cylinder-piston or rack-and-pinion unit, converts the energy of the air supply into mechanical motion to achieve fast opening and closing or continuous control of the valve. It has a simple structure, fast action and strong adaptability, and is widely used…
6 Common Pneumatic Actuator Faults - Causes and Solutions Explained at Once
Introduction Pneumatic actuators are widely used in industrial automation control systems and are characterized by a simple structure, fast response and high safety. However, after long-term operation, various faults inevitably occur under the influence of air supply quality, environmental conditions and operating factors. Knowing how to judge and handle common problems helps you restore equipment operation quickly and ensure production…
Single-Acting Pneumatic Actuator Working Principle - Automatic Reset on Air Loss, the Key to Fail-Safe
Introduction In industries such as petrochemicals, natural gas, power generation and hazardous media transport, the biggest fear is not a valve that breaks down, but equipment that "cannot react in time" when the air supply is suddenly cut off or the power fails. The single-acting pneumatic actuator (Single Acting Pneumatic Actuator) was created precisely for such scenarios - thanks to…
How to Adjust a Pneumatic Control Valve - On-Off vs Proportional Adjustment Explained
Introduction In processes that require precise control of flow, pressure and temperature, the pneumatic control valve plays the leading role. It uses air pressure to control the fluid flow, but many people are not clear about how exactly it should be "adjusted". This article starts from the structure of the pneumatic control valve and focuses on its two adjustment modes,…
Ready to upgrade your automated fluid-control system?
Standard or custom solutions for harsh conditions. HES technical team supports your project.